asmedia 106x sata controller driver windows 10 1.3.8

This required me to turn off driver signing. Since Windows 10 worked, I tried replacing storahci.sys on the existing Windows 2012 R2 setup with the version from Windows 10. Same story, no drives detected, SCSI driver does nothing, STOR driver BSODs. Since 2012 R2 is built on Windows 8.1, I tried clean installing Windows 8.1. I tried loading the Asmedia drivers from the installation screen, and the drivers from the SCSI folder are detected and do nothing, the drivers from the STOR folder causes a BSOD, but no specific error. Same problem as the pre-existing Windows install. It doesn't see the controller, doesn't see the drive. So I decide to try a clean install of Windows Server 2012 R2. Windows 10 uses the Standard AHCI Controller driver as well. It recognized the card and I was able to do a clean install to a fresh drive and it works just fine, drives show up as 'Hard Drive', so I know the card is good. If I install from Setup, it also spontaneously reboots.įor no particular reason, I tried installing Windows 10 Build 10130. Windows does recognize those drivers as matching the card, but if I do a manual driver install, the computer spontaneously reboots. I Googled and found some Asmedia 106x drivers, v.2. They don't show up in Disk Management so I can't assign them drive letters or make them Online. Any drives plugged into it show up as 'Other Devices' and not drives. If I boot up the machine using the motherboard's AMD SATA controller, it detects the card as Standard AHCI Controller. Supposedly, it's compatible with Windows Standard AHCI Controller driver.ĭesired OS is Windows Server 2012 R2. No drivers came with the card, and none available to download. I put it on an MSI AM1I motherboard w/AMD 5350 and 8GB RAM. (The latest version on Station-Drivers is 0.I bought this Syba SI-MPE40095 Mini PCI-e SATA RAID controller, ASM1061R chip. Well I've had a little look in MMTool and in the CSMCORE section the following 2 items appear to be the ASmedia 106x controllerĪs extracting both these modules and opening with a Hex editor it can be seen the OROM version is 0.93

bin file so presume it needs packing into the BIOS somehow. Station-Drivers have a new OROM for the ASmedia controller dated 7/8/12 but its just a. I've just purchased a ASrock z77 extreme4 board to take advantage of TRIM in Win7 and have just modded the bios for the latest Intel OROM, but then it got me thinking about updating the ASmedia controller aswell. However the device ID's will obviously be different. I presume the method is similar/identical to that which we use to update the INTEL OROM as discussed in this thread, by following Fernando's great instructions here I was wondering if any Guru's knew how to update the firmware of the ASmedia SATA 6G controller that is on many of our z77 Boards ?

Asmedia 106x sata controller driver windows 10 1.3.8